Read The Joint Before Anyone Grinds It Out
Mortar joints fail in a few different ways, and each one points somewhere else. Sandy mortar is usually age and weather. A clean gap along the edge of the brick is shrinkage. A crack that climbs the wall in steps may have very little to do with the mortar. Guardian looks at the pattern first, repairs the joints that are a repair job, and tells you plainly when a wall needs a structural look before anyone touches it.
What Failing Mortar Looks Like Up Close
Most people call because they found sand on the sidewalk or a dark line where mortar used to be. That is a good enough reason to call. The useful part comes next: standing at the wall with a flashlight and a screwdriver and working out which kind of failure you actually have. The fix is different for each one, and one of them is not a mortar problem at all.
Sandy Joints That Rub Out With A Finger
This is the most common failure on Chicago brick. From the sidewalk the joint looks intact. Run a key along it and it turns to sand. The lime-rich mortar on older bungalows and two-flats does this after decades of freeze-thaw: water soaks into the joint, freezes, expands and loosens the binder a little more every winter, until what is left is mostly sand held in place by habit.
Sandy joints are a repair job. They get cut back to sound mortar and refilled. The real question is how much of the wall is in that condition, which is why we probe in several spots and on more than one side of the building before we say anything about scope.
Hairline Gaps Along The Edge Of The Brick
Sometimes the mortar is still hard but has let go of the brick, leaving a thin dark line along the top or bottom of the joint. That line is an open door for water. It usually comes from an earlier patch that went in as one thick fill and shrank as it dried, or from mortar so hard that it stopped moving with the brick around it.
A separated joint gets cut out and refilled so the new mortar bonds to both brick faces. Smearing fresh mortar over the line does nothing useful. It sticks to the old surface for a season and then lets go.
Joints That Are Simply Gone
Missing mortar shows up as joints recessed half an inch or more, sometimes with daylight between bricks on a garage or a parapet. You see it most at the top courses of a wall, under sills where water drips off the stone, and at outside corners that take weather from two sides.
Deep voids get packed back in layers. If the brick around a missing joint rocks when you push on it, that brick gets reset before anything is pointed. A loose brick pointed in place stays loose.
A crack that runs through the brick itself is a different conversation than a crack that stays in the mortar.
Cracks, And Which Way They Run
Cracks are where reading the wall matters most. A short crack in one joint, with the brick on both sides sitting flat and even, is usually a weathered joint that gave way. A long crack that zigzags up the wall in a stair-step pattern, following the joints, means the wall moved at some point. That alone is no emergency. Plenty of Chicago houses settled decades ago and stopped. What we look for is whether it is still going, and these signs move a job out of the repair column:
- Brick on one side of a step crack sitting proud of the brick on the other side.
- A crack that is wider at one end, or wider than it was last spring.
- Cracks that run through the brick faces instead of around them.
- A section of wall that bows or bulges when you sight down it from the corner.
- Windows or doors in that wall that started sticking around the same time.
- Cracking at the corners of a window opening, often from a rusting steel lintel pushing the brick up.
When We Stop And Call For A Structural Look
If we see those signs, we say so before any grinder comes off the truck. Pointing over active movement fills the crack for a season, then the wall keeps moving and opens it again, and now the evidence is hidden. A bulging wall or displaced brick gets looked at by someone who evaluates structure, and the joint work follows once the cause is known and dealt with. A straight answer before work starts is how we run every call.
Small Repairs Done So They Hold
Once a joint is confirmed as a repair, the work is plain. Cut it back to roughly two to two and a half times its width, which on most Chicago brick lands between half an inch and three quarters deep. Clean the dust out. Refill with mortar that is softer than the brick, in layers, and tool it to match the joint profile beside it. That last step matters on a front wall, because a concave joint patched with a flush one reads as a patch from across the street.
Send photos through the contact page, a few close-ups plus one shot of the whole wall, and we can usually tell you which kind of problem you have before we visit.
Joint Problems We Repair
Sandy and crumbling joints, hairline separation, missing or recessed joints, and loose brick reset before pointing.
Step cracks with shifted brick and bulging walls get flagged for a structural look first. You hear it before we cut. The gallery is roofing, the trade this crew comes from.
(312) 590-4853How We Sort A Wall
Scratch And Probe
A screwdriver along the joints on every side we are asked about, from the top courses to grade. Soft spots get marked so the scope fits the wall.
Map The Cracks
We note where each crack starts, which way it runs and whether brick has shifted across it. The photos and notes come to you.
Repair Or Structure
Weathered joints go on the repair list. Signs of movement go on a separate list with a plain recommendation for a structural look.
Cut, Fill, Match
Repair joints are cut to depth, packed in layers and tooled to the profile beside them. The site is cleaned before we leave.
Related work: when most of an elevation has gone sandy, mortar joint replacement across the whole wall usually beats chasing spots. Older soft brick calls for tuckpointing restoration with lime-rich mortar. Joints failing under a single downspout belong on a tuckpointing repair list, along with gutter repair to stop the water. Cracks in the top courses of a chimney go through chimney tuckpointing. We read walls in Chicago, Berwyn and Oak Lawn.
Questions About Cracked And Crumbling Joints
How do I tell if my mortar needs repair or just looks old?
Drag a key or a screwdriver along a few joints. If it scratches a light line, the mortar is sound and probably just weathered. If it digs in and turns to sand, or a chunk comes out, that joint needs to be cut out and repointed.
Is a stair-step crack in my brick wall a foundation problem?
Not always. Many older Chicago houses settled long ago and stopped moving. If the brick on both sides of the crack sits flat, the crack is likely stable and the joints can be repaired. If the brick has shifted, the crack is widening or the wall bulges, it needs a structural look before any pointing.
Can you fill the cracks with caulk or mortar paint?
We do not, because neither one repairs anything. Caulk holds water against the brick, and a mortar-colored coating smeared over a joint peels off as the old mortar under it keeps crumbling. A repair means cutting the joint back to sound mortar and refilling it.
Why would you send me to someone else about a cracked wall?
Because pointing over a wall that is still moving hides the problem without stopping it. When we see displaced brick or a bulge, a structural evaluation comes first so the cause gets fixed. Once that is settled, we come back and do the joint work.
Will repaired joints match the rest of the wall?
We match the joint profile and pick a mortar color that sits close to the weathered joints around it. Fresh mortar reads a little brighter at first and softens as it weathers. On a street-facing wall we talk through where a repair will show before we start.
Can mortar joints be repaired in the winter?
Mortar needs temperatures holding above about 40 degrees F while it sets and cures. Past that point the joint has to be tented and heated, or the work waits for spring. A small urgent repair can sometimes be tented, while larger ones usually wait.
Show Us The Joint That Worries You
A close-up of the crack and one photo of the whole wall tell us most of what we need. Call Guardian Roofing or send pictures through the contact page, and you will hear which kind of problem you have before anyone talks about scope.