The Gutter Overflowed For Years. The Brick Kept Count.
On a lot of Buffalo Grove houses the worn mortar is not spread across the front. It sits in a stripe under one corner of the gutter, or in the bottom courses beside a downspout that empties at the wall. Builder gutters on these streets were sized for a gentler decade of rain, and the brick under them has been taking the overflow ever since. We fix where the water comes off the roof, then repair the joints it wore out and blend them into the old wall.
What The Builder Gutters Did To The Brick
Buffalo Grove went up fast between the late 1960s and 1990, with a handful of builders putting up whole sections at a time. The gutters went on the same way: one size, hung to a standard pattern, with downspouts spaced for the storms of that era. The downpours we get now dump more water in an hour than those troughs can carry, so they spill over the front edge in the same spot every heavy rain.
Where that spill lands on brick, the joints take a soaking, freeze that night in winter, and open a little more each season. Decades of that leave a pattern you can read from the street.
A Roof Too Big For Its Gutter
A gutter has to carry everything that drains off the slope above it. On a two-story colonial, the front slope can be a long run of shingles feeding one gutter and one downspout. When the trough fills faster than the outlet can drain it, water goes over the lip. The brick below gets a sheet of water across a few feet of wall, while the rest of the front stays dry. That is why a front can look fine at one end and sandy at the other.
On a split level the roof runs are shorter, but where the lower roof’s gutter hangs just above a brick wall, the overflow has only a few feet to fall before it hits. A short eave throws very little of it clear, and the joints right under the gutter take the rest.
Valleys That Aim At One Corner
The newer houses north of Aptakisic have steeper pitches and more valleys than the 1970s tracts. A valley collects water from two slopes and delivers it to a single point on the gutter, at speed. On a steep roof that water can shoot right past the trough at the corner where the valley lands. If there is brick under that corner, the damage shows up as a narrow vertical band of recessed joints running down from the eave, often with white salt on the face of the brick.
Downspouts That End At The Foundation Course
Plenty of original downspouts end in an elbow a few inches off the ground, aimed at the bottom of the wall. Every storm soaks the first few courses of brick and the foundation course under them, and those joints stay wet longer than anything above grade. They go soft and sandy first. A missing extension or a splash block tipped back toward the house is often the whole cause.
A brick front wears out exactly as fast as the gutter above it lets it.
Fixing The Water On The Same Visit
We are a roofing and gutter company, so the water side is our home ground. Before we price the brick we check these:
- Whether the gutter is big enough for the roof area draining into it, and whether it needs upsizing.
- Pitch toward the outlet, since a trough that holds water spills sooner.
- How many downspouts the run has and where they sit relative to the valleys.
- Where each downspout lets the water go, and whether an extension carries it clear of the wall.
- Hangers and seams, because a sagging section overflows at the low point.
On these houses the fix is often bigger gutters with an added downspout near the problem corner. That work goes in first. Then the joints get repaired, so the new mortar starts life dry.
Blending Into A Faded Builder Mortar
The builder mortar on these fronts has faded and weathered since the house went up, and fresh mortar from the bucket looks brighter and smoother next to it. We match sand color and grain first, because old mortar shows more sand at its surface than new. We match the joint width and the tooled profile too. The repair ends on a staggered edge that follows the brick pattern instead of a straight line, which keeps the boundary from showing. Color is judged once the mortar is dry, since wet mortar always reads darker. Expect it to settle further over a season or two of weather.
One limit is worth saying plainly. Where a crack steps through the brick and the units have moved out of line, or part of the wall bulges, that is a structural question and it gets a structural look before anyone repairs joints. Caulk and smear-over coatings are not repairs either. Our tuckpointing repair page covers spot repair across the rest of the Chicago area, and the gallery shows the crew’s roofing work, gutters included.
Where To Look First
The brick under a valley corner, the courses beside each downspout, and the band just under the eave on the side with the longest roof run.
Booked On A Northern Run
Buffalo Grove work is grouped onto scheduled run days from our Alsip shop, with no travel line on the invoice.
Send a photo through the contact page with the gutter in the frame.
(312) 590-4853From Overflow To Finished Joint
Map The Overflow
We match the damaged stripe on the brick to the valley, gutter corner or downspout feeding it.
Upsize Or Reroute
Bigger gutters, an added downspout or a real extension, so the water stops landing on that wall.
Cut The Failed Band
The stripe under the valley corner is cut back to firm mortar, and the cut stops on a staggered edge.
Pack To Match
Packed in thin layers, tooled to the builder’s crisp joint, and judged against the front only once it has dried.
When the whole front has worn, rather than one stripe, brick tuckpointing on a veneer front is the bigger job, and brick repointing walks through the day itself. A chimney with sandy joints at the top is covered on chimney tuckpointing. If a low porch or sunroom roof meets the brick where the damage is, look at flat roof replacement too. Everything else about the village is on the Buffalo Grove page.
Brick Repair Questions From The North Suburbs
Why is the mortar only bad at one end of the front?
Because the water only lands at that end. A valley or a long roof run overloads one corner of the gutter, and the overflow soaks the same few feet of brick every storm. The rest of the front stays dry and holds up. Trace the stripe upward and you usually find the cause.
Do I really need bigger gutters to fix my brick?
Often, yes. The original builder gutters on many of these houses are undersized for the downpours we get now. If the gutter keeps spilling onto the wall, the repaired joints sit in the same water as the old ones did. Upsizing first is what makes the repair last.
The bottom bricks by my downspout are sandy. Is my foundation in trouble?
Usually not. Those joints wear first because the downspout keeps soaking them, and an extension plus new joints takes care of it. If you see a crack running into the foundation with bricks pushed out of line, that is different, and we will say it needs a structural look first.
Can you match mortar that has faded since the house was built?
Closely. We match sand color and grain, joint width and the tooled profile, then judge the color once the new mortar has dried. A fresh repair still looks slightly cleaner at first, and it settles in after a season or two of weather.
My neighbor had his whole front redone. Do I need the same?
Not necessarily. Houses on one street were built together and age together, but the damage still follows where each roof drains. If your worn joints sit in one or two bands under the water, a section repair fits. If they are spread across the whole front, we will tell you that instead.
Can the gutters and the brick be done on the same run day?
The gutter work usually can, and it goes first. Joint repair needs temperatures holding above about 40 degrees F while the mortar places and cures, so in late fall it may wait for spring. We tell you the order and the timing before anything is scheduled.
Send Us The Corner That Never Dries
Stand back far enough to get the gutter, the downspout and the worn joints in one picture. That photo usually tells us whether you need a small repair, a gutter change, or both. A shot taken during a heavy rain is even better, because it shows exactly where the water goes over.
We put a straight price on it and book it onto the next northern run day. A supervisor is on site while the work goes on, and the site is cleaned before the crew leaves. Reach us through the contact page or call.