Alsip, IL · Mon–Sat 9–5 · BBB A+ Rated Emergency patch response: (312) 590-4853
Call Guardian Roofing (312) 590-4853
Skip to content
Drawing · Short stack, worn top courses
Ranches

Ranch Chimneys After Sixty Years Of Illinois Winters

East of the industrial grid, Elk Grove Village is ranches and split-levels from the 1960s and early 70s, and plenty of them have a short brick chimney rising out of a low roof. Those stacks have taken about sixty years of freeze-thaw, and the house under them is often on its second or third roof. We tuckpoint the chimney and rebuild the flashing where it meets the roof, ideally while the roof is being replaced, so the brick and the shingles finally get finished together.

What Six Decades Do To A Short Ranch Stack

A ranch chimney does not look like much from the street. It is short, it sits on a shallow roof, and nobody gives it a thought until a stain shows up beside the fireplace. Short does not mean sheltered. The courses above the roofline are open on all four faces, snow drifts against them every winter, and each thaw sends water straight to the base where brick meets shingle. The stack is small, and the list of things that can go wrong with it is the same as on a tall one.

Low roofs do make a ranch chimney one of the easier stacks to work on. The crew can reach every face from the roof itself, setup is simple, and the job rarely needs the staging a tall city chimney does. That keeps the repair small, as long as it happens before the top courses start coming loose.

The Courses Just Under The Crown

The joints directly under the crown give out first on almost any chimney, and on a stack this age they have been through a long run of freeze cycles. Water gets in, freezes, pries the joint a little wider and comes back the next storm. On a short stack those top courses can be a large share of all the brick showing above the roof. A chimney that looks only a little rough from the yard can turn out to have most of its exposed joints recessed or loose once someone is standing next to it. We judge it from the roof, never from the lawn.

The crown above those courses decides how much water they see. A cracked crown, or one that sits flush with the brick instead of overhanging it, lets rain run straight down the faces and into the top joints. We check the crown and the cap on every stack, because fresh mortar under a broken crown gets soaked exactly like the mortar it replaced.

Snow Against The Uphill Face

On a low-pitched ranch roof, snow collects behind the chimney and stays. Afternoon sun melts the top of the drift, the water runs down against the brick and the flashing, and the night freezes it in place. That uphill face usually has the worst joints and the most tired metal on the whole stack. On a wider chimney, a cricket built into the roof behind it splits the water to either side, and a reroof is the right moment to add one where the original builder never did.

Flashing Left Over From Earlier Roofs

A house on its third roof has had its chimney flashing worked around at least twice. Each crew had to deal with the metal at the stack, and plenty of them dealt with it using tar, caulk or a strip of metal face-nailed to the brick instead of counter-flashing set into a cut joint. Each layer bought a few seasons and buried the real joint a little deeper. When we redo it, the old material comes off, the step flashing is renewed with the shingles, and the counter-flashing goes back into joints cut to receive it and packed with mortar.

Every reroof that worked around the chimney left another layer of tar on the flashing.

One Visit For The Stack And The Third Roof

The best time to tuckpoint a ranch chimney is while the roof around it is off. The shingles at the base are gone, the step flashing is coming out anyway, and the crew is already set up with roof access and protection. The stack gets tuckpointed first, top down, so falling mortar lands on a roof that is about to be torn off. Then the new roof goes on, fresh step flashing is woven into the courses, and the counter-flashing locks down over it. Reverse that order and the new shingles under the stack spend a day collecting mortar grit.

If your roof still has good years in it, the chimney gets done anyway. The crew covers the shingles around the base and lifts only the courses needed to reach the step flashing. Our chimney tuckpointing page covers the work on taller city stacks, and the Elk Grove Village page covers the rest of what we do on this side of the village.

Reading A Leak Beside The Fireplace

On a ranch, chimney water usually shows up as a stain on the living room ceiling next to the fireplace, or as dark wood around the stack in the attic. When we trace one, we check these in order:

  • The counter-flashing joints, for caulk, open mortar or metal that has pulled away from the brick.
  • The step flashing tucked under the shingles on each side of the stack.
  • The crown, for cracks that let water down into the core of the chimney.
  • The uphill face, where snow and runoff sit the longest.
  • The attic framing and sheathing around the chimney, for staining or soft wood.

One more thing gets a look on every stack. A chimney that leans, bulges or has bricks slid out of line is a structural question before it is a mortar question, and you hear that from us plainly before anybody quotes tuckpointing.

On A Ranch Stack

Top courses under the crown, the uphill face, counter-flashing joints, step flashing, the crown and cap, and the attic framing around the chimney.

A leaning stack or shifted brick gets a structural look before any tuckpointing.

Timing It With The Roof

If the roof is near its end, the chimney goes first, then the new roof and flashing go on around it. The gallery shows the crew’s roofing work.

(312) 590-4853

Stack First, Roof Second

Look From The Roof

Every face, the crown and the flashing get photographed, with the uphill side checked hardest.

Strip The Old Patches

Tar, caulk and face-nailed metal come off so the real joints can be seen.

Tuckpoint Top Down

Failed joints cut to sound mortar and packed in lifts, with the roof below stripped or covered.

Flash Into The Joints

New step flashing with the shingles, counter-flashing set into cut joints and packed tight.

The walls under these chimneys have their own pages in the village. Joints failing under sills and beside downspouts are tuckpointing repair on ranch walls and office fronts, a full wall of 1960s brick is covered under brick tuckpointing, and the way a long elevation is worked day by day is on brick repointing. On the industrial side, acre-scale membranes are handled under flat roof replacement for occupied buildings.

Questions About Ranch Chimneys

Should the chimney be done before or after the new roof?

Before, or during the tear-off. With the old shingles off, the crew tuckpoints the stack top down and lets the debris land on a roof that is coming off anyway. Then the new shingles, step flashing and counter-flashing go on around fresh joints.

Our roof is only a few years old. Can the chimney still be tuckpointed?

Yes. The crew protects the shingles around the base, works from the roof and lifts only the courses needed to reach the step flashing. You keep the roof you have, and the chimney gets fixed without starting the roof over.

Why is the uphill side of our chimney in worse shape?

Snow piles against that face on a low ranch roof and melts into it a little at a time. The brick and flashing on that side stay wet far longer than the other three faces, so they wear out first. On a wider stack, a cricket behind it helps shed that water.

There is tar all over our chimney flashing. Is that a problem?

It usually means the flashing was patched instead of replaced at some point, sometimes more than once. Tar dries, cracks and hides the joint where the counter-flashing should be set. We take it off, see what is underneath and redo the flashing into cut mortar joints.

Can a short chimney really cause a ceiling leak?

Yes. Height has little to do with it. Water that gets past the counter-flashing or through open joints in the top courses runs down inside the stack and the framing around it, and it can show up as a stain near the fireplace or in the attic.

What if the chimney is leaning?

Then mortar is not the first conversation. A lean, a bulge or bricks that have slid out of line is a structural question, and it gets a structural look before anyone talks about tuckpointing. Repointing a stack that is still moving only makes the movement harder to see.

Chimneys

Look At The Chimney Before The Roof Comes Off

If you are pricing a new roof, ask us to look at the chimney on the same visit. A photo of the stack from the yard and one of any stain inside give us a head start before anyone climbs a ladder.

We work the residential blocks east of the industrial park on scheduled runs from Alsip, Monday to Saturday, 9 to 5, with no travel charge. Call, or send the details through the contact page, and you will hear what the chimney needs now and what can wait for the roof.

Protecting the roof that protects you.

The Company

Second-generation roofing and gutters out of Alsip, family-run since 2013. A supervisor on every roof, the site clean at the end of the day, and a straight answer before any work starts. Shingle, metal, flat, TPO, and commercial work across Chicagoland. BBB A+ rated, HomeAdvisor Elite Service award, licensed and insured in Illinois.

EST. 2013 · SECOND GENERATION

Reach Us

© 2026 Guardian Roofing Systems LLC. All rights reserved. BBB A+ · HomeAdvisor Elite Service · Licensed & insured in Illinois